Atlantis AT210 Water Softener

1. A unique electronic controller - made in England.
2. The world's most reliable control valve.
3. Foolproof; push button setup - takes just a few seconds.
4. Meter control is standard.
5. Automatic partial regeneration - saves salt.
6. High efficiency, high capacity resin vessel.
7. One model suits most families.
8. Pulsing LEDs tell you it's functioning correctly.
9. Capable of producing more soft water from
   less salt than any other softener.

Constantly Updated

We don’t change for change’s sake, onlyto make the softener better. Sometimes the improvements are just small things, but over time they add up to make a big difference. Improvements made since the AT210 was first introduced include:

• upgraded electronics that mean the softener uses less salt than ever

• a better overflow system – an adapter makes it easier to change between a set up that is suited to a ground floor installation or for a loft fitting.

• the drain pipe is now a 3⁄8" hose that is 3 metres long. This makes it easy to run along the back of a cupboard, which could reduce the time and cost of installation.

Capable of producing more soft water from less salt than any other water softener

Programmed to regenerate only exhausted resin, an advanced micro chip has been developed to use the least amount of salt and water at the best time of day and night. This ensures that your flow of soft water is disrupted as little as possible and remains consistent whatever time of day or night.

No clock – for trouble free set up

Taking only seconds to set up when installed, the clock-free control system retains settings indefinitely, controlling the remaining capacity of the water softener – even after a power cut. This gives the AT210 the ability to maintain a supply of softened water that matches your individual requirements. Unlike most softeners, the AT210 is so simple to install and set up that commissioning is not necessary.

Meter control is standard

Unlike most water softeners on the market, the AT210 comes with meter control as standard. Meter control manages the regeneration of your softener in line with the amount of soft water used. The meter control ensures that only exhausted resin is regenerated. Meter control should not be confused with the less efficient time-controlled systems available which regenerate at a fixed time of day regardless of how much or how little soft water used.

How the AT210 Water Softener Works

Hard water enters the softener through the inlet and travels down through a bed of ion exchange resin. As the hard water flows through the resin, the calcium and magnesium ions in the hard water are exchanged for sodium ions. The softened water then travels out through the flow meter and into the house. The softening capacity of the resin is limited and it therefore needs to be recharged or regenerated as we call it. The frequency of regeneration depends on how much water is used and how hard the water is.

Features

• Clock-less controller.
• Unique "Double Brining" two brine cycles ensure maximum salt efficiency.
• No covers need removing to set controls.
• Easy set-up only four settings.

This is the high-flow model. Please call us on 01206 582462 if you require low-flow connections to go with this model